F&P Dishwasher

Have an F&P Nemo dishwasher that came with house but no manual. At least 10 years old.
Drainpipe was blocked (from Waste disposal) and machine started beeping. Turned off power, cleared drain. Power on and pump cleared water that had accumulated in washer, but pump still operating and machine still beeping. Lights for Power, Start, etc not showing and cannot see a reset button.
Model number on label on side of door worn away
Going 45 minutes now so will turn off at wall socket
Suggestions please

Check for blocked hose inlet gauze filters.

Which Nemo? There are two. The NZ F&P with the buttons or the China model which had a dial?

Sorry to hear about the issue you're having with your F&P Nemo dishwasher. It can be frustrating when appliances stop working, but there are a few things you can try to troubleshoot the problem.

Firstly, it sounds like the dishwasher is still in "beep" mode, which means it may not have fully reset after the blockage was cleared. One thing you can try is to turn the power off at the wall socket again, wait a few minutes, and then turn it back on. This can sometimes reset the dishwasher and stop the beeping.

If this doesn't work, there are a few other things you can check. Firstly, make sure that the water supply to the dishwasher is turned on and that there are no kinks or blockages in the hose. If the water supply is fine, it's possible that the dishwasher's float switch has been activated, which can happen if water has leaked into the dishwasher's base. In this case, you may need to remove the front kick panel and check for any water in the base, which can be dried out with towels or a wet vac.

Another thing to check is the dishwasher's filter, which can become clogged with food particles and debris over time. You can usually find the filter at the bottom of the dishwasher, and it can be removed and cleaned with warm, soapy water.

Unfortunately, without the model number it can be difficult to provide specific instructions for your dishwasher, as different models may have different features and troubleshooting steps. However, you may be able to find a manual or troubleshooting guide online by searching for "F&P Nemo dishwasher manual" or similar.

If none of these steps work, it may be time to call in a professional appliance repair technician. They will be able to diagnose the issue and provide a quote for any necessary repairs or parts.

In any case, I hope this information is helpful and that you're able to get your dishwasher up and running again soon!

Once it has finished draining the water out, turn off at the wall for a few minutes then turn on again.
Should be silent and in the 'off' mode, ready to go again.

If drain pump is running continuously and won't stop then flood switch in base tray has been triggered. Probably because drain hose was blocked. Try emptying tray by pulling dishwasher forward from under bench and tipping it back as far as you can. See if any water comes out, Once tray is drained it should run again as normal.