Just curious is this actually a requirement or just when there's a council consent!
pauldw,
Feb 13, 3:05pm
Probably like electrical testing - depends who's watching.
budgel,
Feb 13, 9:00pm
Pressure testing is good practice, a sign of a careful tradesman.
I knew a plumber who did a lot of new rural houses where there was oftenno water to connect up to for testing at the time of fitting the pipes.
He made a fitting that connected his pipework to hisacetylene cylinder and tested his joints by holding a lighter flame up to them.
emz24,
Feb 13, 10:57pm
Yes, you have to get it pressure tested to get consent. Usually the inspectors like to see the test on. Otherwise on some building the plumbing firm can do a producers statement, which is pretty much the same thing.
aredwood,
Mar 7, 3:56am
If that is true you should report that plumber. Acetylene has an extremely wide flammability range and a low ignition temp. Almost any mixture of acetylene and air will explode. Even using LPG will still be far safer than using acetylene.
Since the public registrations are closed, you must have an invite from a current member to be able to register and post in this thread.
Have an account? Login here.